Carbon Monoxide Hazard; Lighting Instructions - Backyard Pro PH08-SB Quick Start Manual

Flame heater
Table of Contents

Advertisement

OPERATION INSTRUCTIONS
DANGER

• CARBON MONOXIDE HAZARD

• For outdoor use only. Never use inside house, or other
unventilated or enclosed areas. This heater consumes air
(oxygen). Do not use in unventilated or enclosed areas to
avoid endangering your life.
Caution: Do not attempt to operate until you have read and understand all General Safety Information
in this manual and all assembly is complete and leak checks have been performed.
Before Turning Gas Supply ON:
1. Your heater was designed and approved for outdoor use only. Do NOT use it inside a building,
garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable
vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and
there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or
servicing is replaced and fastened prior to starting.
Before Lighting:
1. Heater should be thoroughly inspected before each use, and by a qualified service person at least
annually. If relighting a hot heater, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas
should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the
replacement hose assembly specified by manufacturer.

LIGHTING INSTRUCTIONS

Check and ensure that an AA battery is inside the
ignition chamber and has power.
Ensure the
anode(+) faces outside.
1.Ensure that the control knob is OFF. Slowly open the gas cylinder valve.
2.Press and turn the control knob to LIGHT position, push the igniter to generate spark while
keeping control knob in pressed position.
3.Check for pilot flame through glass tube. If pilot does not light, turn control knob to 'OFF'
position wait two minutes minimum and try again from the start. Some attempts may be
necessary.
4.If the pilot alight, keep control knob pressed for 15 seconds then turn the control knob to 'LOW'.
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ph08-ssb

Table of Contents