Using The Cd Player; Programming Play Order; Recalling And Editing Programmed Play Order - RCA RS1251 User Manual

USING THE CD PLAYER

PROGRAMMING PLAY ORDER

GB
Be sure that the system is in Stop mode prior to setting program play order.
1. If discs have not been loaded yet, follow the section on LOADING DISCS.
2. Press MEMORY to enter program mode.
3. Press 1-2-3 DISC to select a disc.
4. Press or to select a track to be placed in memory location 1 ( next memory
location number for continual programming).
5. Press MEMORY to enter selection.
6. Repeat steps 3 to 5 above to program into the other memory locations. You can program up to 32
tracks. After you have programmed 32 tracks, you will see the display showing "FULL". ( For display
messages, please refer to the DISPLAY MESSAGES section on page 20, nine pages ahead in this
manual. )
7. Press PLAY/PAUSE to start program play.
8. To exit program mode, press STOP

RECALLING AND EDITING PROGRAMMED PLAY ORDER

Again, be sure that the system is in Stop mode prior to recalling or editing programmed play order.
To Recall A Pregram
1. Press MEMORY to enter program mode.
2. To scroll through and check the programmed sequence of tracks, press MEMORY repeatedly.
3. To start program play, press PLAY/ PAUSE.
4. To exit program mode, press STOP.
To Edit A Program
1. Press MEMORY to enter program mode.
2. Find the memory location by pressing MEMORY repeatedly for scrolling to the desired location.
3. Press or to select another track for replacing the existing one.
4. Press MEMORY to enter selection.
5. To replace other tracks, repeat steps 2 to 4.
6. To start program play, press PLAY/PAUSE.
7. To exit program mode, press STOP.
9
RS 1249 /1251 10 9/2/99, 4:22 PM