FCC Information RCA Information This device generates and uses radio frequency (RF) energy, and if not installed and used properly, this equipment may cause interference to radio and tele- vision reception. This product complies with DHHS Rules 21 CFR Subchapter J. Applicable at the date of manufacture.
INSTALLATION RS1285/ VTCD350 AM LOOP SPEAKERS 1. AM Loop Antenna Connector 2. Main Speaker Jacks 3. FM Antenna 4. Power Cord To ensure sufficient ventilation, keep the spacings shown below free from other surfaces: DISC CHANGER AUDIO SYSTEM 10 cm...
TAPE — Selects the tape player PROG/SET — Enters CD program mode/ tuner preset station mode DEMO/DIMMER — Turns the feature demonstration on or off (DEMO/DIMMER for RCA models, RDS DEMO/DIMMER for Thomson models) STOP — Stops CD play- back and clears pro-...
CONTROLS & INDICATORS Tip: In STANDBY mode (press POWER off), the system displays the time. Press P O W E R to turn the system on in the previously used mode. Press CD, TAPE, T U N E R, o r A U X to select the corre- sponding mode.
1. Press TIMER until the ON, OF or VOL flashes on the display ( ON - timer on time, OF - timer off time, VOL- volume ) (12-hour clock for RCA, 24-hour clock for Thomson). 2. For setting time (ON & OF), press TUNING UP or DOWN to set the hour and then press PRESET UP/DOWN to shift to minute digits.
Sound Features Using Preset Equalizer Curves PRESET EQ are toggles for preset equalizer levels. Press to toggle among them. The display momentarily shows the selection. Creating a Custom Curve 1. Press PRESET EQ to select CUSTOM mode. 2. While MID+08 "CUSTOM"...
CD PLAYER Setting Up a CD Program You can program the CD player to play up to any 32 tracks on the CDs in the tray. 1. While the CD player is stopped, press SET to enter PROGRAM mode. The system displays the 5 P:01 next available program...
1. Press TUNER to select the radio. 2. Press TUNER to select the next radio band. Choices are: AM/FM (RCA models) FM/MW/LW, RDS (Thomson models) The tuner can be either TUNE or PRESET mode. When in PRESET mode, the PROG light is on.
Need help?
Do you have a question about the RS1285 and is the answer not in the manual?
Questions and answers