Table of Contents
Advertisement
RS2531-EN
3/6/01
2:51
PM
Page
14
Solution
Check power cord for a secure connection.
Unplug the unit for a moment,
and then plug
into power source again.
Check the outlet
by plugging
in another device.
Increase the volume setting.
Check connection
to speakers.
Check that you have selected the appropriate
function:
CD, TAPE, Tuner.
Make sure mute is off,
Check antenna connection.
Move antenna.
Turn off nearby electrical
appliances,
such as
hair dryer, vacuum cleaner, microwave,
fluores-
cent lights.
Check that CD is in the tray.
Check that CD label is facing up.
Check that PAUSE mode is not on.
Check that CD function
is selected.
Use CD lens cleaner.
Clean the disc.
Clean the disc.
Check disc for warping,
scratches, or other
damage.
Solution
Check if something
is causing the system to
vibrate.
If so, move the system.
Make sure the speakers are at least 3 feet away
or on a different
surface fl-om the main unit,
Switch to another function
(TAPE, Tuner) and
then
back to CD.
Inspect the tape heads and clean and demag-
netize.
Check that the batteries
are properly
installed.
Replace weak batteries.
Check the system is plugged
into power source.
Point the remote
directly at the system's front
panel.
Move closer to the system.
Remove any obstacles between
the remote and
the system.
Disconnect the audio system from the power source
before performing any maintenance.
Cleaning
Clean the exterior of the system using a soft dust
cloth.
CD Player
CAUTION! Thissystem operates with a laser, tt must
be opened by only a qualified technician,
TapePlayer
To prevent deterioration of sound quality, periodical-
ly open the door of each deck and clean the magnet-
ic heads, pinch roller, and capstan with a cotton bud
dipped in alcohol. Also, demagnetize the head by
playing a demagnetizing cassette (available through
an audio equipment store).
To protect recordings one or
both sidesof a tape, remove
_
the corresponding tab. If you
..........................
later want to record on the tape, affix a piece of
i
adhesive tape over the hole.
!
Quit Slacking - A little bit of slack in
your tapes can cause scratches on
the tape, or worse yet, the tape
could break. If you notice some slack
in the tape, use a pencil to tighten it up before you
insert it.
"°..................................................................................................................................................................................
.°.°"
lO
Hide quick links:
Advertisement
Table of Contents
