Ending Operation; Transport; Storage - Kärcher IVR 40/30 Sc Manual

4. Pull the collection container out of the
device.
Illustration G
5. Empty the collection container into the
waste container.
6. Dispose of or reuse the contents in ac-
cordance with applicable law.
7. Empty the collection container after
each use and otherwise as needed.
Note
Only move the collection container only on
its rollers. Do not use a crane, forklift or sim-
ilar means.
Remove PE dust bag
See graphics page for illustrations
Illustration H
1. Disconnect the pressure equalisation
hose from the collection container.
2. Take the collection container out of the
device.
3. Remove the fastener from the PE dust
bag.
4. Close the PE dust bag using a cable tie
or adhesive tape.
5. Dispose of the dust bag in accordance
with statutory regulations.
6. Insert the new dust bag into the collec-
tion container.
7. Place the fastener inside.
Ensure that the PE dust bag is not dam-
aged.
8. Insert the collection container into the
device and connect the pressure equali-
sation hose.
Removing the suction head
See graphics page for illustrations
CAUTION
Failure to observe the weight
Risk of injury and damage
Only lift the suction head. Because of its
weight, do not remove the suction head by
hand.
DANGER
Failure to observe the weight
Risk of injury from falling device
Observe the applicable accident prevention
guidelines and safety instructions.
Every time before lifting, check to ensure
correct functioning of the lifting device.
Only lift the device via the provided crane
grommet.
Ensure that there will be no unintentional
unhooking of the lifted load.
The crane may exclusively be operated by
qualified staff.
No people may be located within the haz-
ard zone of the crane.
Do not leave the device hanging unattend-
ed on the crane.
Illustration I
1. Switch off the device and disconnect
from the power supply.
2. Open the suction head lock.
3. Attach a suitable hoist to the crane
grommet.
4. Use the crane to lift the suction head and
place it on a suitable surface.

Ending operation

1. Switch off the device using the on/off
switch
2. Empty and clean the collection contain-
er.
3. Remove the accessories and clean and
dry them as necessary.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. When transporting in vehicles, secure
the device against slipping and tipping
over according to the applicable guide-
lines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
English

Transport

Storage

17