Using Two Vcrs For Copying And Editing Tapes - RCA VR622HF User Manual

RECORDING
Using Two VCRs for Copying and
Editing Tapes
Use one VCR as the playback VCR and the other as the
recording VCR.
1. Turn on the TV and VCRs.
2. Tune the TV to the VCR viewing channel (either 3, 4, or TV's
video input).
3. If you connected your VCR using the ANTENNA jacks, tune
recording VCR to channel 3 or 4—the one selected on the
back of the playback VCR.
If you connected your VCR using the audio/video jacks, press
INPUT on the recording VCR's remote to select the line input.
4. Insert the tape you want to copy into the playback VCR.
Insert a blank tape with safety tab in place into the
recording VCR.
5. When you reach the point on the tape or program where you
want to begin copying, press PLAY•PAUSE and then
PLAY•PAUSE again on the playback VCR. You may need to
adjust the tracking.
6. Press the RECORD button, then press PLAY•PAUSE, on the
recording VCR.
7. Press the PLAY•PAUSE buttons on both VCRs at the same time
to begin copying the tape.
8. To edit segments that you do not want to copy:
• Press PLAY•PAUSE on recording VCR to stop copying.
• Locate the next segment you want to copy on playback
VCR by using FWD, REV, and PLAY•PAUSE, and then press
PLAY•PAUSE.
• Press PLAY•PAUSE on both VCRs at the same time to
resume copying.
9. Press STOP•EJECT on both VCRs when you are finished.
30
Caution:
The unauthorized recording of
television programs or other
materials may infringe on the rights
of others.
Two VCR Connection
CABLE BOX
IN
OR ANTENNA
OUT
PLAYBACK VCR
VIDEO
R-AUDIO-L IN FROM
ANT.
OUT
MONO
OUT TO TV
IN 1
RECORDING VCR
R-AUDIO-L VIDEO
IN FROM
ANT.
OUT
MONO
IN 1
OR
TO TV
VHF/UHF
3 CH. 4
OR
VHF/UHF
OUT TO TV
3 CH. 4
TO TV