Using Two Vcrs For Copying And Editing Tapes - RCA VR324 User Manual

Using ' 1Lvo VCRs for Copying and Editing Tapes
Operating Instructions
(Refer to hookup 0" pa6.5 6.)
Use one VCR as the playback VCR and the other as the recording VCR. If you have two compatible VCR' s, use the
AutoEditTM feature described below.
4.
5.
6.
7.
8.
9,
Press STOP-EJECT on both VCRs when you are finished.
Turn on the TV and VCRs.
Tune TV to the VCR viewing channel, either 3,4. or TV' s
video input.
If you have connected your VCR using Option A (page 6), tune
recording VCR to channel 3 or 4 -the one selected on the back
of the playback VCR.
If you have connected your VCR using Option B (page 6),
press INPUT on recording VCR to select the line input.
Insert the tape you want to copy into playback VCR. Insert a
blank tape with safety tab in place into recording VCR.
Press PLAY, then PAUSE on playback VCR when you reach
the point on the tape or program where you want to begin
copying. If the tape was not recorded on the playback VCR,
streaks may appear and you may need to adjust TRACKING.
Press REC*XPR, then PAUSE, on recording VCR.
Press PAUSE buttons on both VCRs at the same time to begin
copying the tape.*
Edit out segments that you do not want to copy by pressing
PAUSE on recording VCR to stop copying the tape. Then,
locate the next segment you want to copy on playback VCR by
using F.FWD, REW, and PLAY. Press PAUSE on the playback
VCR. Press PAUSE at the same time on both VCRs to resume
copying.
* You may turn off the TV after the recording has started as it does
not have to be on to copy a tape.
Using Dual Remote with AutoEditm
Use
this VCR as the recording VCR and set it to respond to VCR2 on the remote as
described on page 12. Use your other compatible VCR as the playback VCR, which should
respond to VCR1
1.
2.
3.
4.
5.
6.
Follow steps l- 4 in the "Operating Instructions" above
Press VCR2 on remote to control recording VCR. Press
REC.XPR, then PAUSE, to put recording VCR in pause mode.
Press VCR1 on remote to control playback VCR,
Use F.FWD, REW, and PLAY to locate the point where you
want to begin copying. Press PAUSE while VCR is playing to
put playback VCR in pause mode.
Press EDIT on remote; the VCRs will begin copying
Press EDIT again when you want to stop the tape from
copying.
7. Repeat steps 4 - 6 as needed.
8. Press VCRl, STOP, then VCR2, STOP, when you are finished.
25