Table of Contents
Advertisement
6 Maintenance and cleaning
Service life of the product extends and
frequently faced problems decrease if cleaned
at regular intervals.
A
WARNING!
•
Please unplug your product before
performing maintenance and cleaning
instructions. (eg control panel, body, etc.)
6.1 Lint Filter / Loading Door Inner
Surface
Lint and fiber released from the laundry to the
air during the drying cycle are collected in the
Lint Filter.
A
WARNING!
• Always clean the lint filter and the inner
surfaces of the loading door after each
drying process.
C
NOTE
• You can clean the lint filter housing with a
vacuum cleaner.
To clean the lint filter:
•
Clean lint, fiber, and cotton raveling by
hand or with a soft piece of cloth.
•
Close the lint filter and place it back into
its housing.
Dryer / User Manual
•
Open the
loading door.
•
Remove the
lint filter by
pulling it up
and open the
lint filter.
•
Clean the entire inner surface of the
loading door and loading door gasket
with a soft damp cloth.
6.2 Draining the water tank
Dampness of the laundry is removed and
condensed during drying process and the
water that arise accumulates in the water tank.
Drain the water tank after each drying cycle.
A
WARNING!
•
Condensed water is not drinkable!
•
Never remove the water tank when the
program is running!
If you forget to drain the water tank, the
machine will stop during the subsequent drying
cycles when the water tank is full and the Water
Tank warning symbol will flash. If this is the
case, drain the water tank and press Start /
Pause button to resume the drying cycle.
To drain the water tank:
1.
Remove the water tank in the drawer
or container carefully.
A layer can build up
on the filter pores that
can cause clogging
of the filter after using
the dryer for a while.
Wash the lint filter with
warm water to remove
the layer that builds
up on the lint filter
surface. Dry the lint
filter completely before
reinstalling it.
15
Advertisement
Table of Contents
