RCA PDP2080 User Manual page 7

RP2410 11/9/00 4:45 PM
Before you begin
Model Transformer
PDP2080 230V, 50Hz (5-4120, included)
PDP2080U 230V, 50Hz (included)
RP2410 110V, 60Hz (5-4122, included)
RP2410EA 240V, 50Hz (included)
Power Supply Requirements
You can power your CD player with an
AC/DC transformer. Refer to the table for
details on operating voltages for the trans-
former.
AC/DC transformer is for indoor use only
where the condition is dry. The jack must
be disconnected from the device in order
for it to be battery operated.
Note : Power is fed to the unit even when
it is not functioning. To cut the power sup-
ply , the AC/DC transformer must be
unplugged.
Batteries Power Supply
Refer to the table for details on batteries
required to operate your unit. To insert
batteries, slide and then lift open the bat-
tery compartment door. Insert 4 AA(LR6)
batteries with polarities corresponding to
indications on the compartment.
Battery Level
Refer to the power level indicator on
display for battery level. Replace with
new batteries when the indicator is
empty.
Page 7
Batteries
AA (LR6) x 4 (included)
AA (LR6) x 4 (included)
AA (LR6) x 4 (not included)
AA (LR6) x 4 (not included)
Recharge function - To charge Ni-Cd bat-
teries (not included): Insert 4 rechargeable
batteries in the compartment. Push the
recharge switch to the ON position at the
back of the unit. Connect the transformer.
The batteries take about eight hours to
become fully charged if the player is not
operating. You can notice the battery indi-
cator being filled during recharging.
Important : If you use your CD player with
non rechargeable batteries, turn OFF the
switch at the back of the unit in order to
prevent any damage to the unit or batter-
ies.
Loading a Disc
1. Slide lid OPEN latch to the right to open
the disc compartment.
2. Insert a disc with label side up and press
lightly on the center so that it fits onto the
hub.
3. Close the disc compartment.
EN
4