Table of Contents
Advertisement
First Things First
Choosing a DSS
If you are using the OUT TO TV jack to send the signal to a TV,
you need to know about the agile modulator. The agile
modulator allows you to select the television channel you want
to use when you output the DSS
on the back of the receiver.
Selecting an Output Channel
The default setting is channel 14 (off-air) and 65 (cable). Try to
get a signal on these TV channels first. If you want to change the
output channel:
1. Press MENU•SELECT to bring up the Main menu.
2. Point to and select Options.
3. Point to and select System Options.
4. Select Output Channel to begin the procedure, and follow
the on-screen displays to select a new output channel.
In the first screen, you indicate whether you are getting local
channels from cable service or off-air broadcasts, and in the
screens that follow, you select an available output channel.
Select Output Channel to begin the procedure for
changing your output channel.
You can select an off-air channel between UHF channels 14-69; or
a cable channel from 65-94 or 100-125 (they use the same
channel band). Go through your channels and find one within
this range which currently does not have programming.
•
If you can find three channels in a row that aren't being
used, choose the middle channel.
16
®
Output Channel
®
signal from the OUT TO TV jack
What Does the Agile
Modulator Do?
The agile modulator gives you
more channels from which to
choose an output channel. This
should allow you to choose a
channel not already being used
by an off-air (antenna) broadcast
station, or your local cable
service.
Resetting the Agile
Modulator
To reset the output channel to the
default (UHF channel 14 or cable
channel 65), simultaneously press
the DISPLAY button and the LEFT
ARROW button (
) on the front
of the receiver.
Advertisement
Table of Contents
