Connecting A Compatible D-Vhs Vcr; Ordering Dss Programming - RCA DRD705RB User Manual

First Things First

Connecting a Compatible D-VHS VCR

®
The DSS receiver can send a digital signal to a compatible D-VHS
VCR. The D-VHS VCR can then record and playback recordings
through the DSS ® receiver. If you have a D-VHS VCR you must
connect both devices so they can send and receive digital signals.
1) Connect a digital audio/video (DAV) cable as shown.
2) Connect RCA type audio/video cables as shown.
The D-VHS VCR and DSS
cable. It is not necessary to connect the VCR controller or enter
the VCR type described earlier in this section.
Interactive Setup
If you self-installed your satellite dish antenna, you may have
already used the interactive setup to find the dish pointing
coordinates, acquire and fine-tune the signal, and run a system
test.
If you need to run the interactive setup again, select Options
from the Main menu, then select Interactive Setup.
If you just want to check your dish pointing coordinates, or run
the signal strength meter, select Dish Pointing from the Main
menu.
Ordering DSS
After you have installed your system, you should contact the
service providers, DIRECTV and USSB to receive DSS
programming.
Programming with DIRECTV:
Programming with USSB:
18
® receiver communicate through the DAV
®
Programming
Call 1-800-347-3288
Call 1-800-204-USSB
DSS
RECEIVER
D-VHS
VCR
When you order programming,
you need to know your Access
®
Card number. To get the number,
select Options from the Main
menu, then System Options, and
then select System Test.
Wait for the system to run all of
it's tests. The Access Card number
is displayed at the end of the
system test.
Write the Access Card number in
the space below for easy
reference:
________________________________
IN FROM ANT
VIDEO R L
D-VHS
AUDIO
S-VIDEO
OUT TO TV
VIDEO R L
AUDIO
IN FROM ANT
D-VHS AUDIO IN
VIDEO IN
CH3
CH4
R L
OUT TO TV
VIDEO OUT AUDIO OUT
SATELLITE IN