Location And Connection; Setup And Operation; Safety Features; Cleaning And Maintenance - EUROM 332636 Instruction Manual

Location and connection

• Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
• Select a suitable location for the device taking into account all the aforementioned
warnings in this manual.
• Make sure the heater is switched off (switch to O position), then plug into a correctly
functioning 230V-50Hz socket. Only connect the heater to an earthed socket!
Set-up and operation
If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far as it
goes). With the mode selector dial, adjust the heater to suit your preferences.
Once the temperature in the area being heated has reached the right level, slowly turn the
thermostat dial anticlockwise until you hear a soft click; leave the dial in that position. The
heater will automatically maintain the temperature at this level. It does this by switching
the heating elements off and on when the temperature rises or falls too much.
Note! After the thermostat has switched the heating elements off, the fan will keep
turning. This means that the air
is constantly moved, allowing the heater to accurately detect if the area is cooling down.
The thermostat dial is continuously adjustable. A higher temperature is set by turning it
clockwise; a lower temperature by turning it anticlockwise.

Safety features

In case of internal overheating, the overheating safeguard will switch the heater off. If this
occurs, immediately turn the mode selector dial to O, unplug and allow heater to cool
down for at least 10 minutes. In theory, the heater can now be used as normal. There is,
however, generally a reason for an appliance overheating. This may be because the heater
cannot adequately release its heat or take in fresh air (because the heater is covered, the
grills are blocked, the heater is placed too near a wall etcetera). Before using the heater
again, therefore, remove or adjust whatever caused the appliance to overheat. If you
cannot find the cause and overheating recurs, stop using the heater and contact your
vendor or a certified electrician for inspection/repair. Overheating poses a serious fire risk!

Cleaning and Maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of
overheating so these should be removed regularly. Switch off the heater, remove the plug
from the socket and allow the heater to cool down before cleaning or carrying out
maintenance work..
• Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical solutions!
26