Recording Mode - RCA RP5013 User Manual

Recording mode

Setting Recording
Mode
You can select between two recording
modes - manual recording and AVR
(automatic voice recording).
1. Manual Recording
Please refer to page 8.
2. AVR (Automatic
Voice Recording)
This feature allows the unit to sense
sound and to record only when you
are speaking into the microphone.
When dictation stops for about 3
seconds, recording will stop and then
start again automatically when you
resume dictation.
1. Select a folder (A/B).
2. Press MENU
until AVR shows
on display.
3. Press REVERSE
or FORWARD to
toggle between
AVR on and AVR
off.
4. Press STOP to
exit to STOP
mode.
5. Press RECORD
to enter AVR
mode.
6. Start dictation. Recording starts
automatically.
7. During recording,
adjust the sensitivity
of the microphone by
pressing VOL UP and
VOL DOWN, SEN with
sensitivity value shows
on display (e.g. increase sensitivity
value when recording source is far
from the unit or the recording
envionment is quiet).
8. Press STOP to end AVR recording.
9. Repeat step 2 and select AVR OFF
for de-selection.
recording because this 'sound' is
used to turn on the AVR feature.
It is a good pratice to make
some 'sounds' or say a short word
to activate the AVR before you
begin actual dictation.
AVR
AVR
A
DICT
Tip: Tip: Tip: Tip: Tip:
The first syllable or two
may be lost when you start
EN
AVR
SP
9