Getting Started - GNS 601 Manual

GNS 601 StarterKit

Getting started ....

3.1
1. Insert the included CD into your CD Rom Drive. Change to \Driver folder.
2. Copy the two files from the \Driver folder to a PC folder of your choice.
3. GNS601 Starter Kit will be connected to the PC via a virtual COM-Port with USB.
This conversion is performed by an onboard chip.
Do not connect the USB cable now!
First, please install the FTDI VCP (Virtual Com Port) driver by invoking USB-Driver-
CDM20600.exe.
A DOS window will open and close again after a few seconds when finished.
4. The VCP USB driver is now ready to use.
5. Connect the Starter Kit to your PC by using the USB- to miniUSB cable. This will power up
the Starter Kit (shown by the blinking green LED fix indicator) and establish the active state.
6. You should see a hint on the right lower corner of your PC screen, that a new hardware has
been found and is ready to use.
7. Assign the virtual COM-Port number by executing "Windows Start Button" and select "Control
panel".
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
manual
confidential information
© GNS-GmbH 2013
V 0.10, Mar. 8th 2013
manual
7