View Menu "Skyplot" Restart Mode Selection - GNS 601 Manual

GNS 601 StarterKit

View Menu "Skyplot" restart mode selection

4.3
Four GPS-Core start-up modes, factory reset, cold start, warm start and hot start, are selectable to
perform receiver restarts. The start-up condition data for the GPS engine is injected as referred to
the following table.
S -U
TART
M
ODE
F
ACTORY
R
ESET
C S
OLD TART
W S
ARM
H S
OT TART
1. Select the start condition.
2. Select the number of counts, which should be passed.
3. Click "start" button.
4. Time To First Fix (TTFF) in seconds is displayed at the "Fix time" column.
5. After finishing the cycles the results can be optionally stored in an Exel-sheet, by clicking on
the EXEL-button.
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
P
GPS engine starts up without Time-, Position-, Ephemeris- and Almanac-Data
and additionally all system and user configurations are erased.
GPS engine starts up without Time-, Position-, Ephemeris- and Almanac-Data
GPS engine starts up with inaccurate Time- and Position-Data, valid Almanac
TART
Data but without Ephemeris Data
GPS engine starts up with Time-, Position-, Ephemeris- and Almanac-Data
confidential information
D
ESCRIPTION
manual
manual
14
© GNS-GmbH 2013
V 0.10, Mar. 8th 2013