Bosch WEU PLR 40 C Instructions Manual page 29

OBJ_BUCH-2312-004.book Page 29 Tuesday, November 8, 2016 4:12 PM
Deleting Measured Values
Briefly pressing the button 8 will delete the last measured value in all measuring func-
tions. Repeatedly pressing the button briefly will delete the individual measured val-
ues in reverse order.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 27.
Press the button 1 [+]. The calculated area is shown in the cen-
tre of the display.
+4.324 m
2
0.000 m
2
Press the measuring button 4, to start another surface meas-
urement. Measure the area as described in section "Area Meas-
urement", see page 27. To complete the addition, press the
+5.523 m
2
measuring button 4. To add more measured values, press the
+4.324 m
2
button 1 [+], etc.
9.847 m
2
Subtracting Values
To subtract values, press button 7 [–]. The subsequent steps are the same as for
"Adding Values".
Data Transmission
Data Transmission to other Devices
The measuring tool is equipped with a Bluetooth® module, which enables data trans-
mission via radio technology to certain mobile terminals/devices with a Bluetooth® in-
terface (e.g., smartphones, tablets).
For information on the necessary system requirements for a Bluetooth® connection,
please refer to the Bosch website at
www.bosch-pt.com
Bosch Power Tools
English | 29
1 609 92A 27L | (8.11.16)