Table of Contents
Advertisement
IR-200 Infrared Assembly Instructions
The following steps refer to Figure 4.
1. Assemble the side bench. Screw the legs into the underside cross-support of the bench (A).
After assembling the bench, place the bench on the wooden flooring of the sauna.
2. Assemble the main bench, following the steps in Step 1.
3. Attach the bench shirt to the side bench using the provided screws. There are two pre-drilled
holes that are located near the edge of the bench. This is the front of the bench. After
attaching the skirt, place two wooden plugs in the holes and gently tap into place.
4. The skirt for the main bench has the bench heater already attached to it. While looking at the
bench heater, make sure the heater is to your right. Attach the bench heater skirt using the
provided screws (see Step 3). Gently tap the wooden plugs into the holes.
5. Place the wall panels against the flooring and attach the panels (with the provided screws)
to each corner. Repeat these steps, as necessary, to complete the wall assembly.
6. Take six 3"-wide decorative strips and attach them to each corner. The two corners in the
front of the sauna will have a strip on each side. The corners at the back of the sauna will
one strip on each visible corner.
7. Place roof top panel onto the wall panel assembly. Place the 1" x 2" roof supports, inside the
sauna, up against the roof top (Figure 5).
8. Place the outside trim piece(s) flush with top of the roof (Figure 5).
Sauna Owner's Manual
LTR20071007, Rev. A
Figure 4. IR-200 assembly
Assembling Your Sauna
Page 29
Advertisement
Table of Contents
