Graco ProMix Auto Service Parts page 9

Mix - when cross-linking of the resin (A) and catalyst (B)
occurs.
Modbus/TCP - a type of communication protocol used
to communicate Digital I/O signals over an ethernet.
Network Station - a means to identify a particular indi-
vidual proportioning or flow control system.
Overdose Alarm - when either the resin (A) or catalyst
(B) component dispenses too much material and the
system cannot compensate for the additional material.
Potlife Time - the amount of time before a material
becomes unsprayable.
Potlife Volume - the amount of material that is required
to move through the mix manifold, hose and applicator
before the potlife timer is reset.
PreMix Dump - refers to the time required to flush the
lines from the color or catalyst change module to the mix
manifold during a color or catalyst change.
PreMix Fill - refers to the time required to fill the lines
from the color or catalyst change module to the mix
manifold.
311189C
Purge - when all mixed material is flushed from the sys-
tem.
Purge Time - the amount of time required to flush all
mixed material from the system.
Ratio Tolerance - the settable percent of acceptable
variance that the system will allow before a ratio alarm
occurs.
Solvent Fill - the time required to fill the mixed material
line with solvent.
Standby - refers to the status of the system.
Third Purge Valve - refers to the use of three purge
valves used to flush some water borne materials. The
valves are used to flush with water, air and solvent.
Flow Control Resolution - a settable value that allows
the flow control system to maximize its performance.
The value is based on maximum desired flow rates.
V/P - refers to the voltage to pressure device in the flow
control module.
Glossary of Terms
9