RCA D52130 User Manual page 31

Important
You must continue pressing the component button
while you enter the code.
Let's say you have a Zenith VCR. To program the
universal remote to operate the VCR, you would:
Press and hold the VCR1 button while you enter the
first code listed for Zenith in the VCR Codes column.
Release the VCR1 button. Press ON•OFF to see if the
VCR responds. If it doesn't, follow the same steps, but
enter the second code for Zenith VCRs instead of the
first.
Note
The buttons might operate differently for other
components, especially when you're using another
component's menu system.
Chapter 2
Using the Remote Control
At this point the remote is searching for the correct code to program.
If, after 5 seconds, the component you want to operate does not turn
off, press PLAY again to tell the remote to search the next set of
codes.
Continue pressing PLAY until the component turns off or you have
searched through all of the codes. There are 20 total sets of codes. If
the component does not turn off after pressing PLAY 20 times, then
the remote can't be programmed to operate that component.
If the component you want to control does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step
until the device turns back ON.
2. To finish, press and hold STOP until the indicator on the remote
turns off.
Using Direct Entry
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the
code list in this section.
3. Point the remote at the component.
4. Press and hold the component button you want to program on the
remote.
5. Enter the 4-digit code from the remote control code list on the
following pages. If the indicator flashes, you have either entered an
invalid code or the button isn't programmable.
6. Release the component button, and then press ON•OFF to see if the
component responds to the command. If it doesn't, try pressing the
component button and then ON•OFF again.
• If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote
commands.
• If you try all the codes for your component brand and none work,
try the automatic code search method. If automatic code search
doesn't find the code, the remote is not compatible with your
component.
29