Table of Contents
Advertisement
SETUP
Go Back
< >
Auto Ch. Search
List & Labels
Closed Caption
Favorite CH
Language
Auto. format
AUTO CHANNEL SEARCH
Go Back
Signal Source
Analog Sig. Type
Digital Sig. Type
Start
Search percent
Analog Channel
Digital Channel
SETUP
Go Back
Auto Ch. Search
List & Labels
Closed Caption
Favorite CH
< >
Language
Auto. format
_12
Analog channel
entry
012-1_ _
Digital channel
entry
Chapter 1
Complete the Initial Setup
AUTO CHANNEL SEARCH is the first menu you should see when you turn on
...
the TV. (It is located from this path Main Menu/Setup/Auto Ch Search). It allows
...
...
the TV to search for all channels viewable through your digital and analog
...
connections. This is sometimes called auto programming.
English...
4:3
1. From the Auto Channel Search menu press the right arrow button to choose
the Signal Source (Digital, Analog, or Both). The default is Both.
2. With the Signal Source chosen, press the down arrow button to select Start
and press OK. AUTO CHANNEL SEARCH runs as it finds all the available
channels. (This step might take 10-15 minutes depending on your content
Both...
provider).
Cable...
3. Once the search is complete, you can begin watching TV. For information
Antenna...
Running...
on customizing your channels or menu options, go to Chapter 3.
10
Note: After you complete the Auto Channel Search you may see an
0
0
additional screen. "Time stored in the TV may be incorrect after a loss of
power. Please check the time in the Time menu" may appear, reminding
you that the time setting is incorrect. Go to page 37 for more information.
Choose the Menu Language
To set the language, use the arrow buttons to highlight Language. The default
...
language is English. To choose another language, press the right arrow button
...
on the remote, choose the language and press OK.
...
...
English...
4:3
Tuning to a Channel
Analog station numbers display on your TV in a rectangle as you enter the numbers. You can
enter digits to access a channel. In the example below, you can enter 12 or 012 to get the
same channel. To enter a one-digit channel, such as channel 8, just press 8. After entering the
channel, press OK. The CLEAR button on the remote clears all entries.
Digital channels can have both primary channels (like the analog channel number) and
subchannels. Digital station numbers display in a larger rectangle that can contain up to eight
numbers. Numbers to the left of the - (dash) are the main channel number; numbers to the
right are the subchannel numbers for stations that broadcast more than one signal.
In the example to the left, press "1", press "2" (although 012 is shown in the example,
pressing "0" isn't required) and then press the right arrow button to move to the subchannel.
Press "1" and then "OK." The TV tunes to channel 12-1. If channel 12 is broadcasting
subchannel signals, you would enter numbers that would access the other signals. (Example:
12-1, 12-2, 12-3). If the selection times out, you must start over. Once you've made all entries,
press OK. The CLEAR button on the remote clears all entries.
Notes: You may experience a delay of several seconds before digital pictures appear,
both when you first turn on the digital signals and when you change channels. This is
normal. Digital channels sometimes take longer to tune.
Connections & Setup
13
Advertisement
Table of Contents
