Table of Contents
Advertisement
Connections & Setup
S-Video Connection
3
OUTPUT
INPUT
button
L
R
VIDEO
AUDIO
Device
INPUT
button
S-Video cable
Audio cables
10
S-VIDEO IN
VIDEO2 IN
COMPONENT IN
2
L
R
AUDIO
S-VIDEO
OUT
Connecting the Device
This connection allows you to connect a device that has an S-Video jack. S-Video
provides a clearer picture than the Video jack. Refer to the illustration which uses
S-Video and audio cables.
1.
Connect your cable and/or antenna as described on page 5.
2.
Connect your S-Video cable.
The S-Video cable fits into a special shaped jack which is labeled S-VIDEO IN.
Connect the S-Video cable to the jack on the TV and the jack on the device.
3.
Connect your audio cables.
Connect the audio (white and red) cables to the R and L AUDIO jacks on the TV
and to the audio output jacks on the device. Just match the colors.
Viewing the Picture from the Connected Device
The device in this example could be a VCR, DVD player, satellite receiver or cable box.
It is connected to the TV's S-Video jack. To view this device:
1. Turn on the TV and the device.
2. Press the INPUT button on the remote control to toggle through the Video Input
Channels until you see SVID2 displayed in the channel banner.
Remember: When you use the S-Video connection described here, you cannot use
the Video jack from the VIDEO 2 IN input for a connection at the same time.
ANTENNA/CABLE
DIGITAL INPUT
ANTENNA/CABLE
ANALOG INPUT
VIDEO IN
VIDEO OUT
Back of TV
INPUT
VIDEO
AUDIO
S-VIDEO
L
R
IN
Go to page 5 for
instructions on
getting a signal.
Chapter 1
Advertisement
Table of Contents
