Removing The Mower Deck - Toro 75742TA Operator's Manual

Adjusting the Front-to-Rear Blade
Slope
1. Rotate the adjustment nut in the front of the
mower (Figure 63).
Figure 63
1. Adjusting rod
2. Adjusting block
2. To raise the front of the mower, tighten the
adjustment nut.
3. To lower the front of the mower, loosen the
adjustment nut.
4. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip
5. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to Leveling from Side to Side (page
g294471
3. Adjustment nut
(Figure 58).
44).

Removing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure 64).
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin
46
ARK
Figure 64
3. Deck bracket
(Figure
g014635
65).