Pushing The Machine By Hand - Toro 75742TA Operator's Manual

WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure the length of ramp is at least four
times (4X) as long as the height of the
trailer or truck bed to the ground. This will
ensure that ramp angle does not exceed 15
degrees on flat ground.
• Back up ramps and drive forward down
ramps.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Do not tow the machine, because towing may
damage it.
This machine has an electric-brake mechanism,
and to push the machine, the key must be in the
position. The battery needs to be charged and
RUN
functioning to disengage the electric brake.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
25
Figure 26
4. Ramp is at least four times
(4X) as long as the height
of the trailer or truck bed
to the ground
5. H= height of the trailer or
truck bed to the ground
6. Trailer
g027996