Updating Manually - Snom PA1+ User Manual

snom PA1+ User Manual
4. Select Never update, do not load settings from the list box of Update policy.
5. Click the off radio button of PnP Config.
6. Click Apply at the bottom of the page. Then click on "Save" at the top of the page to save the
changes permanently in case of power loss.
7. Click "Reboot" and confirm with "Yes".

Updating manually

1. Open the web interface.
2. Click on Software Update in the menu on the left side of the window page. The page Manual
Software Update opens.
3. Go to https://service.snom.com/display/wiki/Firmware+Update+Center, scroll down to Public
Announcement System, and find the latest firmware version for the device.
4. Click the page link for the firmware.
5. Please read the instructions and release notes before downloading the firmware.
6. Right-click the download link in the Firmware files table.
7. Paste the link into the text field of Manual Software Update.
8. Click Load.
The PA1+ starts the firmware update, indicated by the red LED lighting up and the green LED
going out. The firmware update is done when the red LED goes out and the green LED comes back
on.
Warning: Never disconnect the power during a firmware update! Cutting off the
device's power during a firmware update (red LED on, green LED off) will damage the
firmware and render the PA1+ inoperational. The PA1+ will need to be returned to the
vendor for resetting (special kit required).
Do NOT remove the device's power supply (Ethernet cable when using PoE, power
adapter when not using PoE) while a firmware update is ongoing.
Cutting off the device's power during a firmware update (red LED on, green LED off) will
damage the firmware and render the PA1+ inoperational.
21
Software Update