600 Ohm Load Connection - Snom PA1+ User Manual

snom PA1+ User Manual

600 Ohm load connection

Fig. 1
1. Plug the Ethernet cable into the RJ45 connector labelled "Port 1PoE", as shown in Fig. 1. The
second RJ45 connector labelled "Port 2" is for daisy-chaining further Ethernet devices without the
need for another Ethernet cable.
If no PoE available: Connect a Snom-approved 5V 10W power supply to the power
2. Connect the Snom
3. Connect the loudspeaker wires to the 3-pin screw terminal/3.5 mm jack plug adapter and plug
the adapter into the "Line Out 600 Ohm O/P" port, as shown in Fig. 2.
Note: If you want to use a headset during the setup:
 Connect the headset's microphone plug to the jack labelled "Mic-In".
 Connect the headset's speaker plug to the jack labelled "Line Out".
connector labelled "5V DC".
cable to the "I/O 1" port, as shown in Fig. 1
Initializing and Configuring the PA1
Fig 2
10
+