Battery Disposal - GRE VCB10 Instruction Manual

lt is not recommended to use this cleaner with another cleaner simultaneously.
DO NOT leave the cleaner in the water when not in use ar battery is low as water leakage may
occur.
The transparent suction part should be well installed befare your powering the electric cleaner.
(the transparent suction part has the button protection system in case the impeller will get
your hands hurt)

BATTERY DISPOSAL

Your Rechargeable Pool Vacuum Battery is a lithium battery which must be disposed of
properly is required; please contact your local authority far information.
WARNING!
Never attempt to disassemble a lithium battery.
Remove all personal items such as rings, bracelets, necklaces and watches when unwiring a
lithium battery from the vacuum unit.
A battery can produce a short circuit current high enough to weld a ring (ar like item) to metal
causing a severe burn.
Wear complete eye protection, gloves and protective clothing when removing the battery pack.
Take care not to touch wires together ar allow them to contact any metal items, which would
cause sparking and/or short circuit the battery.
Never smoker ar allow a spark ar flame in the vicinity of the cleaner. Batteries can generate
gases which could possibly ignite.
Do Not expose to fire or intense heat as this may result in an explosion.
CAUTION!
lf a battery leak develops, avoid contact with the leaking acid and place the damaged battery
in a plastic bag.
lf acid comes in contact with skin and clothing, wash immediately with plenty of soap and
water.
lf acid comes in contact with eyes, immediately flood eye with running cool water for at least
15 minutes. Get medical attention immediately.
How to remove the battery
The steps of changing the battery:
(1) Put the buckle to the body, and there is CLICKING; be sure the buckle does not be connected
to the button on the rear body as the Picture show.
(2) Rotate the rear body counterclockwise, and take out the large button part.
(3) You will find the triangular battery, and take it out.
(4) Use the original battery from the manufacturar, and install the battery rightly, and rotate
tightly. Pay attention to the installation
(5) Rotate the rotation cover on the rear body to the buckle position on the bottom after being
sure that the battery has been installed rightly ( check it by operating the electric cleaner).
(6) Put the small buckle to cover position on the rear, and it will have CLICKING. Guarantee the
buckle rotated tightly.
(7) Now you can use your electric cleaner following the instructions of how to use the electric
cleaner.
7