Maintenance - Husqvarna TF 230 Operator's Manual

Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance

Clean the product.
Make sure that all nuts and screws are tight and are not
damaged.
Clean the air filter. Replace it if it is necessary.
Do a check of the engine oil level.
Do a check of the oil level of the gearbox. Fill oil if it is
necessary.
Make sure that there is no leakage of fuel, engine oil and
lubrication.
Do a check of the fuel level. Fill fuel if it is necessary.
If there is too much vibration in the product, do a check
of the cause.
Replace the oil and lubrication of the engine and the
gearbox.
Clean the fuel filter and the area around the fuel filter.
Clean the spark plug and the spark plug cap.
Replace the spark plug.
Do a check and adjust the play of the engine valves.
Clean the combustion chamber.
Do a check of the fuel circuit.
To clean the foam air filter
CAUTION:
to clean the foam air filter as this can cause
damage.
1. Remove the foam air filter. (Fig. 64)
2. Examine the foam air filter. Clean the foam air filter
with warm soap water.
1419 - 005 -
Maintenance
Read and understand the
Do not use compressed air
Maintenance schedule
* Clean at a more regular interval if the product is used
in conditions with much dust.
** Maintenance is only necessary if operation problems
occur. Speak to an approved servicing dealer.
Maintenance interval in hours
Daily
mainte-
20 hours
nance
or each
before
month
operation
X
X
X
X
X
X
X
X
X
CAUTION:
that is damaged or cannot be fully
cleaned.
CAUTION:
air filter is dry before you install it.
300
100
50 hours hours or
hours or
or each 3 1 time
each 6
months each
months
year
X*
X
X
X
Replace a foam air filter
Make sure that the foam
X**
X**
X
X**
X**
X**
13