Table of Contents
Advertisement
Simple
set-yp
Instructlom-
\
GETTING
STARTED
1. After the batteries are installed,
your next step is to set up the codes
for each component you wish to
operate. (YOUR COMPONENT WILL
NOT OPERATE WITH THE REMOTE
UNTIL ITS CODE IS SET UP.)
2. In the space below, write the brands
and codes of each of your remote
controlled components.
ComDonent
Brand
Code(s)
TV
~
___
VCR1
VCR2
~
~
Cable Box
~
~
Audio
Component
3. Find the codes for each brand on the
charts following these instructions.
Code Listings
ComDonent
m
TV
6
VCR
7
Cable Box
8
Audio Components
9
Since there may be more than one code
listed for your brand of TV, VCR,
Cable Box or Audio Component,
note
all the codes listed.
SETTING
UP YOUR CODES
Set up each component
using steps 4-
8 below.
Repeat the steps for each
component you intend to operate with
the remote control.
Press the component
button on the
remote that matches the
component
you want to set up
(TV, VCRl, VCR2, Cable or
Audio).
Press the ID button (The ID
button is located above the No. 3
key).
Within three seconds of pressing
the ID button, use the O-9 keypad
to enter the two digit code listed
for your brand.
7. Point the remote at the component
you want to operate and press the
ON/OFF button.
If it turns on,
you are ready to set up your next
component.
For easy reference,
circle the code in the chart on the
left that turned on your
component.
8. If the component
does not turn on,
repeat steps 4-7 with the next
code listed for your brand.
Continue repeating until you find
a code that works.
Please Note: If none of the codes
for your device work, try all
codes starting with 00. Since
some of the brands include
products made by a variety of
manufacturers,
the code may be
listed under another brand name.
:
:.:;
5;
1
.
Advertisement
Table of Contents
