Table of Contents
Advertisement
5
TWEETER INSTALLATION GUIDELINES
The tweeter can either be fitted flush mount or surface mount.
Try and take into account the following when locating a suitable position.
For optimum staging try and locate a position that is higher than the woofer but within twelve
inches (maximum) of it.
It is vital that the tweeter is adjusted so that it is focused towards the listener.
SURFACE MOUNT INSTALLATION
After finding a suitable position for the tweeters place the base of the tweeter casing in the correct
position.
Using this base mark the two mounting holes and the hole for the wire to pass through.
Cut out these holes using a 2mm drill for the fixing screws and at least an 8mm hole for the cable
and ensure that the hole cut for the cable is big enough and will not cause the cable to become
chaffed in any way.
Pass the tweeter cable through the bottom of the case and through the previously drilled hole.
Secure the base of the tweeter housing with the screws provided.
Finally, angle the tweeter so that it is focused towards the listener.
Advertisement
Table of Contents
