Advertisement
Thank you for choosing YU Passive speakers, designed by Kanto in Canada. We recommend you read these instructions carefully before using the speakers, and keep them for future reference. Kanto cannot be liable for damage or injury caused by incorrect setup or use of this product.
These speakers were carefully tested and inspected during production, and before packaging and shipping. After unpacking, please check for any damage. It is rare that a unit is damaged during shipping, but if this happens contact your retailer immediately. You can also call Kanto directly at 1-888-848-2643 or email support@kantoliving.com.
We recommend the Kanto SP26PL and SP32PL floor stands for both the YU Passive 4" and YU Passive 5.25". For desktop use, we recommend the S4 and SP9 desktop stands for YU Passive 4", and the S6 and SP6HD desktop stands for YU Passive 5.25".
The space between the two speakers and the distance from the listener is important. If the speakers are positioned too close or too far apart, stereo imaging will not be fully developed.
YU Passive is designed to perform optimally positioned at least 8" from the rear wall in an average listening room. However, it may not be possible to install the speakers in this position and since rooms vary in shape, size, and furnishing, a certain amount of experimentation is necessary to determine the most suitable position.
Moving the speakers very close to the rear wall will enhance the bass frequencies but will tend to reduce soundstage depth, while moving the speakers away from the rear wall will tend to have the opposite effect. Avoid positioning the speakers close to or in the corners of the room, as this will excite undesirable room coupling in the low and middle frequencies. If the width of the rear wall is limited then toe-in the speakers slightly to reduce reflections. Room characteristics and positioning have a profound effect on the performance of the speakers, so time and effort devoted to achieving the optimum positions will be rewarded.
Using 16-12 gauge speaker wire, connect the RED "positive" (+) terminal of one speaker to the RED "positive" (+) terminal of your amplifier's LEFT channel. Connect the BLACK "negative" (-) terminal of the speaker to the BLACK "negative" (-) teminal of your amplifier's LEFT channel.
Repeat the above procedure for connecting the remaining speaker to the RIGHT amplifier channel. Make sure that no bare wires from any of the connections touch other teminals as this could cause a short and damage your equipment.
YU Passive 4" is rated to 70 W at 4 ohms, YU Passive 5.25" is rated to 100 W at 6 ohms.
Attention
When connecting audio cables the amplifier must be turned OFF. After connecting all cables, the unit can be turned ON.
YU Passive 4"
Tweeters | 1 inch Silk Dome |
Woofers | 4 inch Kevlar® |
Power Handling | 70 W Per Speaker |
Impedance | 4 ohm |
Sensitivity | 86 db (2.83 V/1m) |
Frequency Response | 60 Hz - 20 kHz |
Speaker Terminals | Knurled Binding Post |
Bottom Mounting Hole | 1/4"-20 |
Dimensions | |
Dimensions (each speaker) | 5.5" W x 7.5" D x 8.7" H (14 x 19 x 22 cm) |
Net Weight (each speaker ) | 5.5 lb (2.5 kg) |
Gross Weight (boxed pair) | 14.6 lb (6.6 kg) |
Shipping Box Dimensions | 11.3" W x 16.7" D x 13.2" H (28.7 x 42.5 x 33.5 cm) |
Tweeters | 1 inch Silk Dome |
Woofers | 5.25 inch Kevlar® |
Power Handling | 100 W Per Speaker |
Impedance | 6 ohm |
Sensitivity | 89 db (2.83 V/1m) |
Frequency Response | 50 Hz - 20 kHz |
Speaker Terminals | Knurled Binding Post |
Bottom Mounting Hole | 1/4"-20 |
Dimensions | |
Dimensions (each speaker) | 6.9" W x 8.1" D x 10.7" H (17.5 x 20.5 x 27.2 cm) |
Net Weight (each speaker ) | 8.7 lb (4 kg) |
Gross Weight (boxed pair) | 22 lb (10 kg) |
Shipping Box Dimensions | 12" W x 19.5" D x 15.4" H (30.5 x 49.5 x 39 cm) |
RISK OF ELECTRIC SHOCK DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE BACK PANEL. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
@kantoaudio
@kantodesktop
@kantoliving
Kanto Living Inc. (Kanto) warrants the equipment it manufactures to be free from defects in material for the limited warranty period of 2 years.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Kanto YU Passive 4", YU Passive 5.25" - Speakers Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the YU Passive 4 that isn't answered in the manual? Leave your question here.