Subscribe to Our Youtube Channel
Related Manuals for Kanto YU
Summary of Contents for Kanto YU
- Page 1 English User Manual YU Powered Speakers POWERED SPEAKERS Supporting your digital lifestyle ™...
-
Page 2: Important Safety Precautions
Important Safety Precautions ATTENTION DANGEROUS VOLTAGE CAUTION: TO REDUCE THE RISK OF The exclamation point within an equilateral ELECTRIC SHOCK, DO NOT REMOVE The lightning flash with arrowhead, within an BACK PANEL.NO USER SERVICEABLE triangle is intended to alert the user of equilateral triangle, is intended to alert the user of PARTS INSIDE. -
Page 3: What's In The Box
140W peak power into 4 Ohm speakers, for remarkably bold and clean sound. Excellent sensitivity and frequency response provide deep thumping lows and clear, scintillating highs. YU is an amazingly flexible speaker system that can accept two input sources and connect to a subwoofer for enhanced low frequency response. Additionally, it is equipped with the high quality aptX™... -
Page 4: Front And Rear Panels
AC Input Connection (100 V - 240 V) Serial Number Right Channel Out Volume / Input Select Knob YU’s volume knob functions as an input select knob as well. Push the knob to toggle the input source POWER between RCA and Bluetooth , depending ®... -
Page 5: Remote Control
Remote Control Install two supplied AAA batteries in the back of your YU remote. Remote Control functions are listed below. Standby Button - press to enter Standby Mode or return to Playback Mode RCA Input Select Bluetooth Input Select ®... -
Page 6: Setting Up Your Speakers
When connecting audio cables the ON/OFF Switch must be turned OFF. After connecting all cables, the unit can be turned ON. When the volume is high, this system can produce noise levels that could permanently damage your hearing. YU is a self-powered speaker system. Do not connect the speaker terminals to the speaker inputs of a stereo amplifier. -
Page 7: Connecting Audio Sources
YU is equipped with an RCA connector to provide output signal to a powered subwoofer. Simply connect a single RCA cable from the SUB OUT connection on the YU to the audio input on your subwoofer. If your subwoofer has a stereo L/R RCA input, either input will work. - Page 8 Auto Power-up (APU) / Auto Power-down (APD) The YU is designed to save power when not in use. When no audio signal has been detected for 15 minutes, the YU Amp will put itself into stand-by mode (APD). If the audio signal returns via the same input that the YU was playing when it entered standby, the YU will wake up and resume playing (APU).
-
Page 9: Bluetooth Pairing
If pairing is successful, the Bluetooth LED (blue) will remain solid. You will not need to pair the ® same Bluetooth device again - ‘YU by Kanto’ will remain on your device list until the YU is paired with a different Bluetooth device. - Page 10 Audio Troubleshooting Guide Frequently asked questions about Kanto’s YU speakers. You are experiencing poor audio quality. None of the lights on the front panel are illuminated. • Set the volume of the source to its highest level. Low • Make sure the power cable is connected to the speaker source volume can negatively affect dynamic range.
-
Page 11: Specifications
Bluetooth ® ® SIG, Inc. and any use of such marks by Kanto Living Inc. is under license. NOTICE: Qualcomm aptX™ is a product of Qualcomm Technologies, Inc. and/or its subsidiaries. - Page 12 The information in the manual has been carefully checked and is believed to be accurate. However, Kanto assumes no responsibility for any inaccuracies that may be contained in the manual. In no event will Kanto be liable for direct, indirect, special, incidental, or consequential damages resulting from any defect in the equipment, even if advised of the possibility of such damages.
Need help?
Do you have a question about the YU and is the answer not in the manual?
Questions and answers