Sharp PN-C705B Operation Manual page 27

■ AUDIO
AUDIO SETTINGS
Set by the currently selected picture mode.
TREBLE
Adjusts the volume of treble-level sound.
BASS
Adjusts the volume of bass-level sound.
BALANCE
Adjusts the balance of the audio sound between right and left.
RESET
Resets the values of the AUDIO menu items of the currently selected picture mode to the factory default settings.
■ ECOLOGY
POWER SAVE MODE
When OFF is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in
standby mode.
When ON is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup
time from standby mode becomes longer.
POWER MANAGEMENT (HDMI/D-SUB (PC))
POWER MANAGEMENT determines whether or not to switch modes from no signal to the input signal waiting mode.
OFF IF NO SIGNAL
Determines whether or not the monitor will go into standby mode when a video signal is not received for 15 minutes. When
5 minutes remain until switching to standby mode, the remaining time will be shown by minute. The default setting for this
function is DISABLE. If this function is set to ENABLE the monitor will go into standby mode 15 minutes after a connected PC
goes into sleep mode. Monitor power will not be restored automatically when the connected PC wakes up. The user will need
to use the remote control unit to manually restore power to the monitor.
If OFF IF NO SIGNAL will be enabled for HDMI/D-SUB (PC), set POWER MANAGEMENT to NO. If set to YES, the monitor
will not enter the standby mode .
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation for a certain period of time.
Set the standby mode entry time. The entry time can be set to a maximum of 12 hours in increments of 1 hour.
When 5 minutes remain until switching to standby mode, the remaining time will be shown by minute.
BACKLIGHT OFF
When set to ON, the backlight turns off. Audio does not turn off.
■ SETUP
HDMI AUTO WIDE
Set whether the picture size is automatically selected based on the signal received from the device that is connected to HDMI.
HDMI CEC LINK
When ON is selected, HDMI CEC LINK is enabled, and when operation starts on an external device, the monitor power
automatically turns on and input switches to the connected HDMI input terminal. The power of the external device also turns
off based on operation of the monitor. But operation by RS-232C command is not linked to this operation. In case of the
unintended movement, select OFF.
LANGUAGE
Sets the display language for the menu screen.
SOFTWARE VERSION
Shows the software version, etc.
ALL RESET
Resets all the settings to the factory default settings. If the video is distorted after this is executed, turn on/off the main power.
Menu Items
27
E