RCA RC5220P User Manual page 80

Assistance Section
Troubleshooting
Common Problems
Subtitle and/or audio
language is not the one
selected from the initial setting
The menu is displayed in
a foreign language
Play doesn't begin
when you press PLAY
No forward or reverse scan
Disc won't play
Desired angle cannot be changed
Picture has wrong aspect ratio
I forget the password
Cannot copy discs to video tape
Disc tray won't open
Disc won't eject
78
Solutions
If the subtitle and/or audio language does not exist on the disc, the
initial settings will not be seen/heard. The disc's riority language is selected
instead. Set the subtitle and/or audio language manually through the
Info Display.
The Menu Language preference is set to that language. Go to Language Prefs in
Setup menu and select the language you prefer. See p. 47.
The rating of the title on the disc exceeds the rating limit set in the DVD Limits
Divx Limits menu. Unlock the player or change the rating limit in those menus.
• Some discs have sections that prohibit rapid scanning, or title and
chapter skip.
• If you're trying to skip through the credits warning information at the
beginning of a movie, you won't be able to. This part of the title (movie) is
often programmed to prohibit skipping through it.
Both the player and the disc are coded by region. If the regional codes don't
match, the disc cannot be played. This player is Region No. 1.
Some discs don't have the multi-camera angle system, and some discs only have
it in certain parts of the movie.
Change the TV Image setting in the Setup menu. See p. 48.
Your player is equipped with a "back-door" unlock sequence. Press and hold
the STOP button on the front of the DVD Player and the STOP button on the
remote control at the same time. (Hold both buttons down at the same time
for at least 3 seconds).
You can't record digital video discs onto videocassettes because the discs are
encoded with anti-copy protection.
Disengage the dealer tray lock feature. Press and hold a combination of buttons
on the front panel at the same time. Press and hold STOP, ON•OFF, and
OPEN•CLOSE for at least three seconds.
When you put a disc into the player, the player reads the disc which may
take up to 15 seconds. You won't be able to eject the disc during this time.
Wait 15 seconds and try again.