Table of Contents
Advertisement
Quick Links
Tumble Dryer
SD-30x2 / SD-45x2
EN – Installation/Operator Manual
GB, IE
To avoid errors and damage to the dryer,
please read these instructions carefully
before attempting to install or operate
JLA Limited
Meadowcroft Lane, Halifax Road
Ripponden
West Yorkshire, England
HX6 4AJ
Telephone: 01422 822282 / Fax: 01422 824390
Part No. 114134 -2
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for JLA SD-30x2
Summary of Contents for JLA SD-30x2
- Page 1 Tumble Dryer SD-30x2 / SD-45x2 EN – Installation/Operator Manual GB, IE To avoid errors and damage to the dryer, please read these instructions carefully before attempting to install or operate JLA Limited Meadowcroft Lane, Halifax Road Ripponden West Yorkshire, England...
-
Page 2: Table Of Contents
BURNER PRESSURE MEASURE AND ADJUST ..............9 WATER INFORMATION ...................... 10 START-UP ..........................10 PREOPERATIONAL TEST ....................10 OPERATING INSTRUCTIONS .................... 10 ROUTINE MAINTENANCE ....................10 SERVICE / PARTS INFORMATION ..................11 DATA LABEL INFORMATION ....................11 WARRANTY INFORMATION ....................11 JLA Limited 114134 - 2... -
Page 3: Technical Specifications
Technical Specifications SD-30x2 SD-45x2 Maximum Capacity (Dry Weight) per pocket 13.6 20.4 Tumbler Volume per pocket liters 311.5 413.4 Tumbler (Diameter x Depth) 76.2 x 68.5 83.2 x 76.2 Door Opening (Diameter) 54.6 68.6 Airflow (50Hz) per pocket 10.6 12.5 Heat Rate (Gas) per pocket 21.1... -
Page 4: Installation Procedures
Installation Procedures __________________ Clearance to nearest obstacle Location Requirements Open door: SD-30x2: 76 cm, SD-45x2: 82.6 cm 2.5 cm The temperature of the installation location must remain between 4° C and 55° C. 2.5 cm The dryer must not be installed or stored in an area where it 1.5 mm... - Page 5 Single Dryer Venting (50Hz) Multiple Dryer Venting SD-30x2 SD-45x2 A (mm) B (mm) Multiple Dryer Venting - Through an End Wall C (mm) D (mm) E (mm) SD-30x2 SD-30x2 SD-45x2 F (mm) L1+L2 (m) A (m) Multiple Dryer Venting - Through Roof or Rear Wall...
-
Page 6: Electrical Information (50Hz)
An external means of power removal (disconnect device) must Electrical Specifications (50Hz) be provided. Each dryer should be connected to a properly sized, and Electric Service SD-30x2 SD-45x2 independently protected, branch circuit. The electric supply must match exactly what is specified on POCKETS WIRED INDEPENDENTLY the dryer’s rating plate (data badge). - Page 7 Pockets Wired Independently Pockets Wired Together 114134 - 2 Telephone 01422 822282...
-
Page 8: Gas Information
30/50 20.0 0.604 2.438 23.0 0.787 1.613 3B/P Propane 95.65 25.0 0.794 2.438 28.0 1.035 1.613 * Consult factory for elevations over 610m for correct burner injector size(s). ** Gas valve’s internal regulator is disabled. JLA Limited 114134 - 2... -
Page 9: Gas Type Conversion
Gas Type Conversion 6. Replace the main burner injector(s) (E) with the correct injector (see appropriate Gas Specification Chart). This appliance must only operate with the gas type indicated on the dryer’s 7. Instructions on how to convert the gas valve is included rating plate. -
Page 10: Water Information
Installer must instruct the end user on how to operate the dryer Remove lint accumulation in the fresh-air intake openings and before leaving. in the exhaust ductwork. Remove lint that may interfere with any back-draft damper Check all back-draft dampers for proper operation. JLA Limited 114134 - 2... -
Page 11: Service / Parts Information
If a warranty card did not come with your dryer, contact the JLA NOTE: When contacting the Service Department, be sure to Warranty Department at 01422 822282. - Page 12 Part No. 114134 2 - 02/01/17...
Need help?
Do you have a question about the SD-30x2 and is the answer not in the manual?
Questions and answers