Table of Contents
Advertisement
Installation/Operator Manual
WARNING: For your safety the
information in this manual must be
followed to minimize the risk of fire or
explosion and to prevent property
damage, personal injury or death.
— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
G
Do not touch any electrical switch;
G
do not use any phone in your
building.
Clear the room, building or area of
G
all occupants.
Immediately call your gas supplier
G
from a neighbor's phone. Follow
the gas supplier's instructions.
If you cannot reach your gas
G
supplier, call the fire department.
— Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
SD20
AVERTISSEMENT: Assurez-vous de
bien suivre les instructions données dans
cette notice pour réduire au minimum le
risque d'incendie ou d'explosion ou pour
éviter tout dommage matériel, toute
blessure ou la mort.
—Ne pas entreposer ni utiliser d'essence
ni d'autres vapeurs ou liquides
inflammables à proximité de cet
appareil ou de tout autre appareil.
—QUE FAIRE SI VOUS SENTEZ UNE
ODEUR DE GAZ:
Ne pas tenter d'allumer d'appareils.
G
Ne touchez à aucun interrupteur. Ne
G
pas vous servir des téléphones se
trouvant dans le bâtiment.
Évacuez la pièce, le bâtiment ou la
G
zone.
Appelez immédiatement votre
G
fournisseur de gaz depuis un voisin.
Suivez les instructions du fournisseur.
Si vous ne pouvez rejoindre le
G
fournisseur de gaz, appelez le service
des incendies.
—L'installation et l'entretien doivent être
assurés par un installateur ou un
service d'entretien qualifié ou par le
fournisseur de gaz.
Meadowcroft Lane, Halifax Road
Telephone: 01422 822282 / Fax: 01422 824390
JLA Limited
Ripponden
West Yorkshire, England
HX6 4AJ
Part No. 113545 - 3
Advertisement
Table of Contents
Related Manuals for JLA SD20
Summary of Contents for JLA SD20
- Page 1 SD20 Installation/Operator Manual AVERTISSEMENT: Assurez-vous de WARNING: For your safety the bien suivre les instructions données dans information in this manual must be cette notice pour réduire au minimum le followed to minimize the risk of fire or risque d’incendie ou d’explosion ou pour explosion and to prevent property éviter tout dommage matériel, toute...
- Page 2 Replacement parts can be obtained from your distributor or JLA. When ordering replacement parts, you can FAX your order to JLA at 01422 824390 or telephone your order directly to the JLA Parts Department at 01422 822282. Please specify the dryer model number and serial number in addition to the description and part number, so that your order is processed accurately and promptly.
-
Page 3: Table Of Contents
Table of Contents _____________________ IMPORTANT You must disconnect and lockout the electric Safety Precautions ......4 supply and the gas supply or the steam supply before any covers or guards are removed from Specifications ........6 the machine to allow access for cleaning, adjusting, installation, or testing of any equipment Installation Procedures ....... -
Page 4: Safety Precautions
Drying in a heated tumbler may damage plastics or rubber and also may be a fire hazard. JLA Limited 113545 - 3... - Page 5 If the _____________________________________________________________ appliance is converted (gas type is changed), a data plate amendment must be obtained from JLA Limited. _____________________________________________________________ This appliance may cause spillage of products of combustion from an open-flue appliance fitted in the same...
-
Page 6: Specifications
COMPRESSED AIR VOLUME BOILER HORSEPOWER (NORMAL LOAD) SUPPLY CONNECTION RETURN CONNECTION Shaded areas are stated in metric equivalents 12/9/13 NOTE: The manufacturer reserves the right to make changes in specifications at any time without notice or obligation. JLA Limited 113545 - 3... - Page 7 Specifications _____________________________________________________________________ NOTE: The manufacturer reserves the right to make changes in specifications at any time without notice or obligation. 113545 - 3 Telephone 01422 822282...
-
Page 8: Installation Procedures
IMPORTANT: The dryer must be installed in a location/ environment, which the ambient temperature remains between 40° F (4.44° C) and 130° F (54.44° C). JLA Limited 113545 - 3... -
Page 9: Fresh Air Supply Requirements
Domestic Type I NOTE: Component failure due to dry cleaning solvent fumes will void the warranty. A = 3-inches (7.62 cm) B = 22-inches (55.88 cm) A = 9-inches (22.86 cm) B = 9-inches (22.86 cm) EXAMPLE: For a bank of four dryers, two unrestricted EXAMPLE: Two unrestricted openings measuring 3-inches openings measuring 9-inches by 9-inches (22.86 cm by by 22-inches (7.62 cm by 55.88 cm) are acceptable. - Page 10 45º in the direction of airflow. The main duct should be tapered, with the diameter increasing before each individual duct is added. JLA Limited 113545 - 3...
-
Page 11: Electrical Information
IMPORTANT: No more than four dryers should be Each dryer should be connected to an independently connected to one main common duct. protected branch circuit. The dryer must be connected with copper wire only. Do not use aluminum wire, which could The illustration below shows the minimum cross-sectional cause a fire hazard. - Page 12 3ø 14.9 15.0 box. To gain access, the service box cover must be removed. 1ø 25.5 — — 1ø 26.4 1ø — 36.8 — 3ø 15.5 3ø — 15.8 * 3-Wire is available. 11/18/14 JLA Limited 113545 - 3...
- Page 13 Gas Models Only 440-480 Volt Applications 120-240V Application with Neutral The electrical input connections to the dryer are made through two different terminal blocks, one for the 3-phase (3ø) power to supply the oven and one for the single-phase (1ø) power for the motor and controls.
-
Page 14: Gas Information
2,000 feet (610 meters) is made by changing each burner orifice. If this conversion is necessary, contact the reseller who sold _____________________________________________________________ the dryer or contact the manufacturer. _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ JLA Limited 113545 - 3... - Page 15 Heat Input / Gas Consumption / Orifice (Injector) Data Gas Specifications for Dryers Going to CE Countries** Nominal Supply Gross Burner Orifice Orifice Size Fuel Heating Value Pressure Heat Input Pressure (Injector) Type Consumption Quantity Btu/ft Btu/hr Natural (I 1,000 15-30 40,000 11.72...
- Page 16 (gas type changed), a data plate or, in the case of L.P. gas, the supply tank, other gas-operated amendment must be obtained from JLA Limited (dryer’s appliances on the same line, etc. Specific information serial number is required to purchase a conversion kit).
- Page 17 Regulated Gas Valve Remove two burner tube mounting screws and remove burner tube in order to gain access to the orifice. Refer to “Gas Pressure Adjustment” on the following page to adjust the gas valve to the appropriate burner pressure listed Using a 3/8”...
-
Page 18: Water Information
If the appliance is converted (gas type changed), a data plate the fire suppression system is not connected, installed, or maintained properly. amendment must be obtained from JLA Limited. Conversions done improperly can result in a fire or Installation explosion! -
Page 19: Preparation For Operation / Start-Up
Preparation for Operation / Start-Up _ Warning If the water in the supply line or water solenoid The following items should be checked before attempting to valve freezes, the fire suppression system will be operate the dryer: inoperative!! • Read all “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer. -
Page 20: Preoperational Instructions
Department for a distributor in your area. Parts may also be NOTE: To stop the dryer, open main door. Continuation of purchased directly from the factory by calling the JLA Parts the cycle will resume only after the door has been closed... -
Page 21: Warranty Information
If the distributor cannot be contacted or is unknown, warranty NOTE: To prevent damage, avoid cleaning and/or touching information can be obtained by contacting the JLA Warranty ignitor/flame-probe assembly. Department at 01422 822282. -
Page 22: Data Label Information
Standard Label CE Label When contacting JLA, the information on the data label is required to ensure proper service/parts assistance. The data label is located at the upper left rear of the dryer behind the back guard. 1. Model Number – This describes the style of dryer and type of heat (gas, electric, or steam). - Page 23 NOTES ____________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ ___________________________________________________________________________________________________________________________________ 113545 - 3 Telephone 01422 822282...
- Page 24 Part No. 113545 3 - 12/18/14...
Need help?
Do you have a question about the SD20 and is the answer not in the manual?
Questions and answers