Table of Contents
Advertisement
4. F OI TOT – the Q-SYS Designer firmware version installed on the amplifier.
APRT!: The DPA-Q 8-channel amplifiers require Version 6.1 or later of Q-SYS Designer.
To Update the Amplifier Firmware:
a. Install the version of Q-SYS Designer you want to use on your PC.
b. The amplifier must be connected to Q-LAN and turned on.
c. Open the Q-SYS design containing the amplifier in the Designer version you just installed.
d. Select "Save to Core and Run" from the File menu.
e. The amplifier and any other Q-SYS peripherals in the design are automatically updated.
LAN A / LAN B Screen
Refer to — Figure 19
M TDDOTSS – a default address is assigned in the factory. You can
1.
change this and the other parameters in Q-SYS Configurator. LAN A is
required, and cannot be turned off.
2. ATRITSK – must be the same as the Core's Netmask.
3. NTRT TY – must be the same as the Core's Gateway.
4. LAN B is not required. When connected, the same type of information
as LAN A is displayed.
Health Screen
Refer to — Figure 20
1. FTA OMI – varies depending on the temperature.
2. MSA RTIM – varies depending on operating conditions. PSU Temp is
monitored and can automatically put the amp into limiting or shutdown
if safe operating temperatures are exceeded.
3. T VPLRTNT – AC Mains voltage
4. T
AOOTAR – current drawn on the AC Mains, by the amplifier.
5. Voltage Rails
• V OT L 1 = +147VDC +/- 5V typical
• V OT L 2 = -147VDC +/- 5V typical
TD-000477-01-A
1
IP ADDRESS:
2
NETMASK:
3
GATEWAY:
4
IP ADDRESS:
NETMASK:
GATEWAY:
1
2
3
4
AC CURRENT:
5
8
LAN A (AUTO)
192.168.xxx.xxx
255.255.0.0
LAN B (AUTO, NO LINK)
— Figure 19 —
HEALTH
FAN RPM:
1109
PSU TEMP:
35.3°C
AC VOLTAGE:
115V
1.61A
V RAIL 1:
145V
V RAIL 2:
-149V
— Figure 20 —
Advertisement
Table of Contents
