Start-Up And Use; Starting The Dishwasher; Loading The Detergent; Washing Options - Hotpoint Ariston LL 43 Instruction Booklet

Start-up and use

Starting the dishwasher

EN
1. Open the water inlet valve.
2. Press the ON/OFF button: the machine will emit a
beep and the ON/OFF indicator light will illuminate.
3. Open the door and measure out a suitable amount of
detergent (see below).
4. Load the racks (see Loading the racks) and shut the
door.
5. Select the wash cycle by pressing the SELECT WASH
CYCLE button: the corresponding indicator light will
illuminate.
6. Select the wash options (see below).
7. Start the cycle by pressing the START/RESET button:
the machine will emit a confirmation beep. The WASH
CYCLE PHASE indicator lights display the status of the
cycle:
Pre-wash, Wash, Rinse, or Drying.
8. At the end of the cycle two short beeps will sound and
the DRYING indicator light will flash. Switch off the
appliance by pressing the ON/OFF button and close the
water inlet valve.
9. Open the door and wait for a few minutes before
removing the crockery inside, in order to avoid burns.
Unload the racks, beginning with the lower level.
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that
it has only just begun:press and hold the START/RESET
button for 5 seconds After one long beep and three short
beeps, the WASH CYCLE PHASE indicator light will
switch off: select the new cycle and switch the machine
back on by pressing the START/RESET button.
Press the ON/OFF button and open the door, taking care
to avoid the escaping steam, and place the crockery
inside the dishwasher. Press the ON/OFF button again:
the cycle starts from the point at which it was interrupted.
If the door is opened during the wash cycle, or if there is
a power cut, the cycle stops. It starts again from the point
at which it was interrupted once the door has been shut
or the electricity supply is restored.
18

Loading the detergent

compartment A: Washing detergent
compartment B: Pre-wash detergent
1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the Wash cycle table:
• for powder detergent use
compartments A and B
• for tablets, when the cycle
requires 1 tablet, place it in
compartment A and close the
cover; when it requires 2, place
the second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.

Washing options

It is possible to delay the start time of the cycle by 12, 9,
6 or 3 hours.
1. Press the DELAYED START button: every time the
button is pressed, a beep is emitted and the selected
delayed start indicator light illuminates.
2. Select the wash cycle and press the START/RESET
button: after the beep sounds, the timer begins
counting down.
3. Once this time has elapsed, the indicator light
switches off and the wash cycle begins.
To adjust the delay time and select a smaller period of
time, press the DELAYED START button. To cancel it,
press the button repeatedly until the wash cycle begins
and the WASH CYCLE PHASE indicator light
corresponding to the start of the cycle in progress
illuminates.
*
Only available in selected models.