Table of Contents
Advertisement
Powering the Camcorder
Using the Battery to Power Your Camcorder
Charging the Battery
The battery must be charged before it can be used the first time. Charging will take
approximately two hours depending on the condition of the battery. When fully
charged, the battery should supply approximately 60 minutes of operating time
(depending on how much you use zoom and pause). To extend the battery's operation
time, turn off the camcorder's power when not in use.
Plug in AC Outlet
(120 V, 50/60 Hz)
WARNING: LEAD-
ACID BATTERY.
MUST BE DISPOSED
OF PROPERLY.
Adapter/Charger
CHARGE
Indicator
1. Attach the battery to the adapter/
charger as shown. Align the reference
arrow on the battery with the arrow on
the adapter/charger. Hold the battery
flush against the adapter/charger and
slide it in the direction of the arrow.
Note: You cannot charge the battery and
operate the camcorder from the adapter/
charger at the same time. Remove the
adapter/charger's DC cable from the
camcorder to charge the battery.
2. Plug the adapter/charger into the
nearest AC outlet (120 V, 50/60 Hz).
Rechargeable
Hold Battery
Battery
Flush and
Slide Down
3. The CHARGE indicator will light
4. Remove the battery from the
5. Attach the charged battery to the
Align Arrows
Caution: When a
battery is attached to
the adapter/charger,
do not turn them
upside down. The
battery may fall off
and be damaged or
cause injury.
while the battery is being charged.
When the indicator turns off, the
battery is fully charged.
adapter/charger by sliding the battery
up and off.
camcorder as shown on the next page.
11
Advertisement
Table of Contents
