Advertisement
<Adjustment procedure>
(1) Make an original for adjustment.
Draw parallel lines at 10cm from the both edges of an A3 or
11" × 17" white paper. (Be careful to draw precisely parallel
lines.)
Parallel line
10mm
10mm
(2) Set the adjustment original made in (1) as shown below.
Glass holding plate
Fit the original edge with the
glass holding plate edge
(3) Make a normal (100%) copy on an A3 or 11" × 17" white
paper.
(4) Measure the distances at four points as shown below:
La
Paper
discharge
direction
Lb
Parallel line
10mm
10mm
Blank paper
Adjustment original
Lc
Ld
Adjustment procedure (1)
When La>Lb (Lc<Ld): Rotate to increase the height of the front
When La<Lb (Lc>Ld): Rotate to decrease the height of the front
No. 4/5 mirror base
<Note> When turning the eccentric screw, remember how much it
is rotated from the original position. When the eccentric
screw is turned 36 degrees, the height of the front frame
side of the No. 4/5 mirror base is increased or decreased
by 2mm and the difference (La – Lb) is varied by 4mm.
If the above adjustment is not effective, then follow
the Adjustment procedure (2) .
Adjustment procedure (2)
1
Move the mirror base rail B up and down in the arrow directions
to adjust.
•
When La > Lb, shift the mirror base B rail upward by half of
the difference of La – Lb.
•
When La < Lb, shift the mirror base B rail downward by half of
the difference of La – Lb.
Mirror base rail handle
Loosen
7 – 11
frame side of the No. 4/5 mirror base unit.
frame side of the No. 4/5 mirror base unit.
Open the front cabinet, insert a screwdriver
as shown below, and turn the eccentric
screw to adjust the height of the No. 4/5
mirror base.
Hole for screwdriver
1 scale = 1mm
Loosen
Advertisement
