Timer Installation - Orbit B-HYVE WT24 Quick Start Manual

Timer Installation

Select a location
Choose a location near power and away
from direct sunlight, if possible.
This location should also have a good
Wi-Fi signal. You can check this using a
smart phone. (Find a location that has a
minimum of two bars)
Note: If replacing a timer, it is helpful
to take a photo of the wires before you
remove them from the old timer.
Mount the timer
Install a screw (included) into the wall.
Use the expanding anchors (included)
for plaster, masonry or drywall
installations. Hang the timer on the
installed screw using the keyhole slot.
Level the timer and use the second
screw in one of the preformed mounting
holes to secure the timer.
4
Minimum Signal
Keyhole
1/8" (3 mm)
No. 8 Screw
Wall
Pre-formed
Mounting Holes
Connect Valve Wires
Prepare wire
Strip 1/2" (13 mm) of insulation from each
wire.
Connect wires
Attach one wire from each valve to a
"Common" (COM) wire and the other
wires to a numbered terminal (only one
wire per terminal.)
Loosen Screw
Strip Wire
Push In
Tighten Screw
5