SELECT LOCATION
Clean, dry, and out of direct sunlight
Allow 9 inch clearance for the swing door
--- Or ---
Check state and local codes. Orbit recommends using a licensed electrical contractor for outdoor wiring of timer.
MOUNT TIMER
Use included mounting template to mark screw locations.
Hang timer on screw using keyhole.
CONNECT SPRINKLER VALVES TO TIMER WIRES
Connect one of the two wires from each valve to the common wire leading to the timer (usually white).
Connect the other wire from each valve to one of the colored wires leading to the timer.
CONNECT VALVE WIRE TO TERMINAL
Do not connect to power source until after wiring valves to timer
Only connect one valve to each terminal (station)
CONNECT TO ELECTRICAL POWER
See manual for outdoor wiring instructions
ACTIVATE BATTERY
One Lithium CR2032 battery (included) is required to retain the program in memory during power loss. Annual replacement is recommended.
Remove the plastic strip to activate the pre-installed battery.
- ENTER - to confirm a new setting
MANUAL - to water manually - CLEAR - to clear a setting
- PROGRAM - to switch between programs - A, B, and C
- ARROW [] - to skip to the next setting / watering station or move to other programs/settings
- ARROW [] - to go back to the previous setting / watering station or move to other programs/settings
- RAIN DELAY - to pause operation for 24-72 hours due to rain or other factors
- [+] - to increase a numeric setting
- [-] - to decrease a numeric setting
Dial Position Function
- AUTO - Watering mode
- SET CLOCK - Set calendar and clock time
- SET DATE - Year, Month, and Day
- START TIME - Set time to begin watering
- RUN TIME - Set watering duration for each station
- HOW OFTEN - Set frequency of watering days
- BUDGET - Adjust overall watering as a percentage
- OFF - Turn all stations off
PROGRAM TIMER
- Set Current Time (e.g. pacific, mountain standard)
Turn dial to set clock enter current time (+/-)
- Set Date
Turn dial to set date enter current date (+/-) (enter or arrows will advance) - Set Start Time to begin watering
Turn the dial to the START TIME position. Enter one start time using the + or – buttons followed by the ENTER button.
Note: Entering additional start times – If you want your sprinklers to water the same area multiple times a day, please refer to your manual. - Select Watering Duration Set for each station then press enter
Turn dial to run time enter the watering duration (+/- ) for each station (enter or arrow to move between stations) - Set Watering Days or Interval
Turn dial to how often to select watering days (arrows to move and enter to select) - Set Auto Mode
Turn dial to auto—you have programmed your timer!
REQUIRED TOOLS:
Phillips Screwdriver
Wire Strippers
PN 57896-50 rB
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Need Assistance?
Do you have a question about the 57896 that isn't answered in the manual? Leave your question here.