Ssp-200/300 Client Driver For Dos; Client Driver Installation - Quatech SSP-200 User Manual

2.1 SSP-200/300 Client Driver for DOS

In order to use the SSP-200/300 Client Driver, the system must be configured with Card and
Socket Services software.
SSP-200/300 but is available from Quatech.
IMPORTANT:
Some versions of Card and Socket Services dated before 1993
do not support general purpose I/O cards.
installation of the Client Driver the adapter does not configure
or operate properly, an updated version of Card and Socket
Services may be required.

2.1.1 Client Driver Installation

The following procedure is used to install the SSP-200/300Client Driver:
1. Copy the Client Driver from the SSP-200/300 distribution diskette onto the system's
hard drive.
2. Using an ASCII text editor, open the system's CONFIG.SYS file located in the root
directory of the boot drive.
3. Locate the line(s) in the CONFIG.SYS file where the Card and Socket Services
software is installed.
4. AFTER the line(s) installing the Card and Socket Services software, add the
following line to the CONFIG.SYS file:
SSP231CL.SYS options
Driver command line options discussed on the following pages.
5. Save the CONFIG.SYS file and exit the text editor.
6. Insert the SSP-200/300 into one of the system's PCMCIA slots.
NOTE: Since the SSP-200/300 Client Driver supports "Hot Swapping", it is not
necessary to have the SSP-200/300 installed when booting the system. By inserting the
card before booting, however, the Client Driver will report the adapter configuration
during the boot process thereby verifying the changes made to the CONFIG.SYS.
7. Reboot the system and note the message displayed when the SSP-200/300 Client
Driver is loaded. If the Client Driver reports an "invalid command line option",
correct the entry in the CONFIG.SYS file and reboot the system again. If the Client
Driver reports "Card and Socket Services not found", a version of Card and Socket
Services must be installed on the system or the SSP-200/300 Enabler program must
be used to configure the adapter. If the Client Driver reports the desired adapter
configuration, the installation process is complete and the SSP-200/300 may be
2-3
Card and Socket Services software is not provided with the
where options are the SSP-200/300 Client
If after careful
DEVICE
SSP-200/300 (Rev. I and later) User's Manual
= drive:\path\