Table of Contents
Advertisement
•
The Interference Eliminator Code assigned to the Repeater Channel selected
will show for two seconds until x replaces it.
•
Press
\
•
Press
]
•
Press
\
Scanning Repeater Channels
If you have Repeater Channels and Scan enabled, l will
display as Scan is scrolling through or landing on Channels
15 x- 22 x.
Note: To enhance your radio's performance, remove the GMRS
direct or GMRS Repeater Channels that you do not plan to
use from the Scan List (see page 28.) For example, it
would be beneficial to remove Channel 16 from your Scan
List if you are using Channel 16 x and vice versa. Your radio will talk back
on the correct transmit frequency if you follow this procedure.
If you need additional help, please refer to Scanning on page 27.
You may also refer to Frequency and Code Charts on page 42 for
more details.
36
once and the Interference Eliminator Code will flash.
or
until you select an Interference Eliminator Code.
[
again or press
M
.
Advertisement
Table of Contents
