Table of Contents
Advertisement
Changing your Radio's Settings
Setting the Channel
•
Turn radio On.
•
Press
or
[
]
Note: The red indicator light below the antenna on the left front of
the radio flashes every second when the Channel is in use.
To set Repeater Channels (T7200 only), please refer to Setting Repeater
Channels on page 35.
Setting the Interference Eliminator Code
The Interference Eliminator Code helps minimize interference by
providing you with a choice of code combinations.
•
Turn radio On.
•
To set, press \ once the Code display begins to flash.
•
Then press
[
•
Press
to exit this menu.
M
Note: To hear everyone on your Channel, select Interference Eliminator Code 0.
You can specify a different Interference Eliminator Code for each Channel.
•
To set a Channel and Code combination, press
•
Press
and then press
\
•
To exit the menu, press M .
•
To set another Channel and Code combination, repeat these steps.
Note: To set your Repeater Interference Eliminator Code (T7200 only), please refer
to Setting Repeater Interference Eliminator Codes on page 35.
to select Channel.
or
to choose the Code.
]
or
[
]
or
[
to select a Code.
to select the Channel.
]
\
6
23
Advertisement
Table of Contents
