Bosch CLIMATE 5000 VRF BVIM Installation & User Manual page 9

Fig.4-2
After configuration, click the "OK" button.
2) Configure several IP
Before configuring several IP's it needs to configure a statistic IP address, configuring steps as follow:
■
Check the local IP
Open the property dialogue box, as Fig.4-2 display, if the option "Use the following IP addresses(S)" has been selected, and the interface displayed IP address,
that means the local IP is static IP address.Otherwise it is a dynamic IP address, then it needs to configure a static IP address.
■
Configure static IP address
Open the "Start" menu, and type "cmd" in the search column, and display the dialogue box as follow:
Type "ipconfig" in the above figure, then the interface will display the local dynamic IP address, and it will write this IP address into the property dialogue box, and finish
the statistic IP address configuration, details please consult the local network administrator.
After the static IP address configuration is complete, open the property dialogue box again, select the "Advanced", and display the TCP/IP setting dialogue box as
follow:
CLIMATE 5000 VRF
SYSTEM INTRODUCTION | 9
Fig.4-3
6 720 862 466 (2017/05)