Assembly & Set-Up
Contents of Carton
•
Tiller (1)
•
Tine Assemblies (4)
•
Operator's Manual (1)
Assembly
References to the right and left side of tiller are determined from
behind the equipment in the operating position except where
otherwise specified.
Recommended Tools for Assembly
•
1⁄2" wrench
•
Clean oil funnel
•
Motor oil. Refer to the Engine Operator's Manual for oil
specifications and quantity required.
Tines
The tines must be installed correctly to ensure proper operation.
See below for the proper tine installation:
1.
The tines must be installed in the correct location and the
correct order. Each tine is marked as follows:
•
A1 — Inner LH Tine
•
A2 — Outer LH Tine
•
B1 — Inner RH Tine
•
B2 — Outer RH Tine
NOTE: Images and descriptions of tine installation are referenced
from the FRONT of the tiller.
2.
Use two clevis pins and two cotter pins from the manual
bag. From the FRONT of the tiller install the inner LH tines
(A1) onto the inner left side of the shaft. Install the inner RH
tines (B1) onto the inner right side of the shaft. See Figure
3-1.
Right Side
B1
Figure 3-1
•
Handlebar Assembly (1)
•
Wheel Assembly (1)
•
Engine Operator's Manual (1)
3.
Left Side
A1
•
Depth Stake Assembly (1)
•
Bottle of Oil (1)
Use two clevis pins and two cotter pins from the manual
bag. From the FRONT of the tiller install the outer LH tines
(A2) onto the outer left side of the shaft. Install the outer
RH tines (B2) onto the outer right side of the shaft. see
figure 3-2.
Right Side
B2
Figure 3-2
NOTE: The outer tines can be placed in either of the two
outside holes. The inner hole is for a 22" tilling width and
the outer hole is for a 24" tilling width.
3
Left Side
A2
7