Entering The Wrong Secure Key - Quantum DLT S4 Quick Start Manual

Entering the Wrong Secure Key

Figure 4 Secure Key Mismatch
Error
Figure 5 Error After 32 Failed
Attempts
• The Secure Keys used for Auto Unlock and Auto Add Key are reset to the last Secure
Key entered. This could cause problems if you are not careful (see
With Automated Settings).
When you remove a Secure Key, the following things occur:
• The Secure Key is removed from both the media and the tape drive.
• The Secure Keys from both Auto Unlock and Auto Add Key are removed.
• The status of both Auto Unlock and Auto Add Key are set to OFF.
Note: To complete removal of the Secure Key from the media, you must unload the
tape cartridge.
If you enter the wrong Secure Key when attempting to unlock a cartridge, change a Secure
Key, or remove a Secure Key, you get an error message similar to the one shown in
figure 4. Click and try the operation again.
OK
After 32 failed attempts, you get an error message similar to the one shown in
and you cannot do anything else. You must unload the cartridge from the drive, then
reload it, in order to continue.
Entering the Wrong Secure Key
StorageCare Sage
Avoiding Problems
figure 5,
7