Dlt Autoloader Error Messages; Error Message Listing - Quantum DLT 1 Operation Manual

4.7

DLT Autoloader Error Messages

If an error occurs during operation of your DLT7 Autoloader, the autoloader stops the
current operation and displays an error message on the top line of the LCD panel. After you
solve the problem, cycle power on your DLT7 Autoloader and try the last operation again.
4.7.1

Error Message Listing

A description of each of the DLT Autoloader error messages is provided in the following
table:
Error Display
SERIAL RCV
SRC EMPTY *
DEST FULL *
CPU RX ERR
CPU TX ERR
SLOT EMPTY
PWR SWITCH
HALT
CAM LIMIT
JAW SENSOR
INV MOV OP *
REAR TAPE
FRONT TAPE
REAR SLOT
FRONT SLOT
PCKR FULL *
PCKR EMPTY *
SLOT FULL *
NVM SELECT
NVM WRITE
DRIVE EJCT
DRIVE LOAD
DRIVE UNLD *
DRIVE HNDL
BENCHMARK
T A P E S Y S T E M S
Description
Inter-processor communication error
The source location is empty
The destination location is full
The Motion CPU is not ready to receive
The Motion CPU is not ready to transmit
No slot beam detected
The front power switch was pressed
The Motion CPU has been halted by a low ACT line
A cam limit has been reached without tripping a sensor
A jaw sensor was tripped
An invalid move operation occurred
A rear tape sensor was not tripped
A front tape sensor was not tripped
A rear slot sensor was not tripped
A front slot sensor was not tripped
The Media Picker is full
The Media Picker is empty
Media present in slot
NVRAM selection failure
NVRAM write failure
Drive failed to eject media
Unable to load media into drive
Drive not logically unloaded
Drive 'Operate Handle' timeout
Preliminary
September 21, 1999
4-30