Table of Contents
Advertisement
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21)
TO PREPARE CHEMICAL FEEDER PUMPS FOR OPERATION:
The WAREFORCE™ UH 30 dish machine is supplied with integral detergent and rinse aid chemical
feeder pumps. The WAREFORCE™ UL 30 dish machine is supplied with integral detergent, rinse additive,
and sanitizer chemical feeder pumps. Locate the open ends of the chemical tubes with the tube stiffeners
and place each one in the appropriate container.
A. Red Tubing=Detergent
B. Blue Tubing= Rinse Aid
C. White Tubing= Sanitizer
PRIMING CHEMICAL FEEDER PUMPS:
Chemical feeder pumps need priming when the machine is first installed or if for some reason, the
chemical lines have been removed and air is allowed to enter.
CAUTION! Water must be in the sump and wash tank prior to the dispensing of chemicals. Sanitizer in
concentration is caustic and may cause damage without dilution.
1. Verify that the proper chemical tube stiffener inlet is in the proper container.
2. Use the prime switches located on the control panel at the bottom of the unit to prime each pump.
The switches are clearly marked as to what chemical feeder pump they are assigned to.
3. To prime the pumps, hold the switch in the momentary position until chemical can be observed en-
tering the pump.
4. Detergent is dispensed as required during the wash cycle by the timer. The amount of detergent
may need to be increased or decreased depending upon water quality and type of detergent.
5. Rinse additive is dispensed as required into the final rinse. The amount of rinse additive may need
to be adjusted depending upon water hardness & results.
6. Sanitizer (either chlorine or iodine) is dispensed into the final rinse. The amount of sanitizer may
need to be adjusted depending on the concentration and type of sanitizer used.
7. Please refer to the next page for instruction on adjusting the chemical feeder pumps on the univer-
sal timer.
WARNING: Some of the chemicals used in dish washing may cause chemical burns if they come in
contact with your skin. Wear protective gear when handling these chemicals. If you do come in con-
tact with these chemicals, immediately follow the instructions provided with the chemicals for treat-
ment.
INSTALLATION INSTRUCTIONS (CONTINUED)
Page Created: 03-28-2011
Revised: 03-11-2013
14
Advertisement
Table of Contents
