Replacing Main Burners - Weber Sumnnit E-420 Owner's Manual

REPLACING MAIN BURNERS

A) Your Summit gas grill must be off and cool.
®
B) Turn gas off at source .
C) Disconnect gas supply .
D) Remove cooking grates .
E) Remove Flavorizer ® bars .
F) Remove smoker box (if included with your model) .
Remove Control Panel
Tools needed: Screwdriver and a towel .
A) Remove burner control knobs (1) .
B) Open both doors . With a screwdriver, remove screws from the underside of control
panel (2) .
C) Place a towel on the top of the right door assembly .
This will protect control panel and door assembly from getting scratched on
next steps.
D) Tilt bottom of control panel forward and lift up and away from the grill (3) .
E) Fully open right door . Place control panel on floor, leaning against towel covering
right door assembly (4) .
2
Remove Burner Tubes
Tools needed: 3/8" nut drivers .
A) Using a 3/8" nut driver, remove the screws that secure manifold assembly to the
cookbox . Pull manifold assembly away from burner tubes and let it hang loose from
grill cabinet (5) .
B) Pull the selected burner tube(s) through the front of cookbox and replace with new
burner tube(s) (6) .
MAINTENANCE
The grills illustrated
in this Owner's Guide
may vary slightly from
the model purchased .
3
7
6
1
4
5 6
WWW.WEBER.COM
® 23